AdapterID 0280h AdapterName "Systech 6280 Host Adapter" NumBytes 4 NamedItem Prompt "Bus Memory Address" Choice "8DC00000h" pos[1]=XXXXX000b mem 8dC00000h-8dc1ffffh Choice "8DC20000h" pos[1]=XXXXX001b mem 8dC20000h-8dc3ffffh Choice "8DD00000h" pos[1]=XXXXX010b mem 8dd00000h-8dc1ffffh Choice "8DD20000h" pos[1]=XXXXX011b mem 8dd20000h-8dd3ffffh Choice "8DE00000h" pos[1]=XXXXX100b mem 8de00000h-8de1ffffh Choice "8DE20000h" pos[1]=XXXXX101b mem 8de20000h-8de3ffffh Choice "8DF00000h" pos[1]=XXXXX110b mem 8df00000h-8df1ffffh Choice "8DF20000h" pos[1]=XXXXX111b mem 8df20000h-8df3ffffh Help "This field sets the MCA bus address range the HPS will respond to." NamedItem Prompt "Upper Address Bits 31->28" Choice "8" pos[2]=1000XXXXb Help "This field sets the upper address range the HPS will respond to." NamedItem Prompt "Interrupt Selection is 10" Choice "10" pos[1]=xxx00xxxb Choice "11" pos[1]=xxx01xxxb Choice "12" pos[1]=xxx10xxxb Choice "15" pos[1]=xxx11xxxb Help "Sets up the interrupt level the board will use." NamedItem Prompt "Network Node ID" Choice "F0" pos[2]=xxxx0000b Choice "F1" pos[2]=xxxx0001b Choice "F2" pos[2]=xxxx0010b Choice "F3" pos[2]=xxxx0011b Choice "F4" pos[2]=xxxx0100b Choice "F5" pos[2]=xxxx0101b Choice "F6" pos[2]=xxxx0110b Choice "F7" pos[2]=xxxx0111b Choice "F8" pos[2]=xxxx1000b Choice "F9" pos[2]=xxxx1001b Choice "FA" pos[2]=xxxx1010b Choice "FB" pos[2]=xxxx1011b Choice "FC" pos[2]=xxxx1100b Choice "FD" pos[2]=xxxx1101b Choice "FE" pos[2]=xxxx1110b Choice "FF" pos[2]=xxxx1111b Help "Select network id from f0-ff." NamedItem Prompt "Host Handshake" Choice "Enabled" pos[3]=XXXX0XXXb Choice "Disabled" pos[3]=XXXX1XXXb Help "Enable/disable the host handshake." NamedItem Prompt "Ram Test" Choice "Short" pos[3]=XXX1XXXXb Choice "Long" pos[3]=XXX0XXXXb Help "Use the short/long version of the ram test." NamedItem Prompt "Real-Time Clock Period" Choice "52 ms" pos[3]=11XXX110b Help "Set the RTC to 52 ms, no Channel Check , No status" ;end of file