The 2nd set of Multistation, 5551-G06 came to hand on 2003.5.1.
I want to tell the details here.
I received the computer of having been due to discard from a certain man.
There were no less than 5577 printers with sheet feeder in fact.
However, since there was no place to set, it was not able to obtain.
Although starting from a hard disk is possible, a data error occurs, and even
if it is going to read from a diskette drive, can generate an error and it cannot
It may become a huge ornament immediately....
Composition of hardware
Partition of Hard Disk
"Bunsyo Program" which is the word processor started by the original system
is installed into the partition of exclusive use.
Software already set up
The inside is divided into three portions, the substrate, the drive, and the slot.
Please have a look about a pictures here.
Planar P/N 6342394 EC No.865251-4
Many LSI tips have appeared in the huge substrate.
A memory is 256KB in total in 64Kbit LSI tip x32 piece.
Although CPU is usually called 8086, since it is 8MHz, it is 8086-2 correctly.
The TEST switch and LED for a system test are attached.
Although there is a parallel port, but there is no serial port.
Since a planer is inserted in the slot of a case, there is no connector of a power
Display board P/N 6342396 EC 865251-3
It is the personal computer of IBM too that the display board is another.
Although the difference between a color model and a monochrome model is based on
this display board, it is needed.